Procedure
- Source
- Target
NOTE: First make the connections, then move to code compilation.
1. Drag and drop BreadBoard, Arduino and all other Components first.
2. Connect PinA with Pin 1 of Breadboard.
3. Connect PinV with Pin 2 of Breadboard.
4. Connect PinG with Pin 3 of Breadboard.
5. Connect Pin 1 with Pin 11 of Arduino.
6. Connect Pin 5 of Breadboard with GND Pin of Arduino.
7. Connect Pin4 of breadboard with 5V Pin of Arduino.
8. Click on "Check Conn." button to check the connections.
9. For the code compiler:
- Set Servo motor as____ "attach".
- Set the angle to "180".
10. Now, click on "COMPILE" button to run and check the code.
11. Click on "RESET" button to reload the webpage.